Print Page - System Not reading Cards Memory

Title: System Not reading Cards Memory
Post by: mg1969 on 28 August 2007, 11:22:10

I have got two Techworks 12mb Voodoo 2 cards running in SLI. A recent problem has developed where only 1 of the cards memory is being registered in the System Info (4mb Frame buffer, 8mb Texture), despite SLI being detected.

Any ideas what is going on here?

Title: System Not reading Cards Memory
Post by: ps47 on 28 August 2007, 16:54:37

as long as games run fine,ignore it.try launching glquake and open the console,it should give you accurate info about your card(s).

Title: System Not reading Cards Memory
Post by: mg1969 on 28 August 2007, 22:25:27

oh ok, thanks for the advice ps47. I'll install Quake with GL patch, go into console as you say and see what it says.

Is there a command I need to type in to get this info up, or is it automatically displayed once in the console?

Thank you.

Title: System Not reading Cards Memory
Post by: ps47 on 29 August 2007, 18:04:08

its auto,just hit the tilde~ key once the game starts.

Title: System Not reading Cards Memory
Post by: mg1969 on 29 August 2007, 18:47:33

thanks

3dfxzone.it WorldWide Community

3dfx Hardware & Software => Voodoo2 Setup and tweaking => Topic started by: mg1969 on 28 August 2007, 11:22:10