Notice ~ 

Are you searching for our italian Community  Forumzone.it?
Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - BaldiGit

#1
General Discussions / 3DFX Maxi Gamer Phoenix PCI
07 October 2023, 21:29:52
Can someone guide me in the installation and testing of the PCI maxi Gamer banshee?
I have a Fujitsu Siemens D1064 motherboard, with a Pentium 2 400MHz and 198Mb of RAM. Plus a PCI SoundBlaster card. I have done a fresh install of Windows 2000 Pro and installed the Guillemot 4.1.02.02 driver, which is telling me I have BIOS version 1.00.10 installed. There are no exclamation marks in Device Manager and all drivers are present. And the Maxi Gamer utility thinks the card is there.
 
I have installed Deux Ex which recognises the Banshee and tries to use 3DFX drivers. But get an error of "HWCEXT not implemented". I have also tried Quake2 + 3DFX patch and that crashes out. But I can't access the initial error message. But the game reports "Server was Killed". Probably caused by me trying to get out of a grey screen.

Personally I think the accelerator part of the card isn't working. But I'm not sure if its something software I'm not doing, Or a hardware issue. Any advice would be most welcome. 
#2
General Discussions / Test programs
13 May 2021, 12:18:46
I'm trying to test a couple of Voodoo cards, a Banshee, voodoo 1 and a voodoo 2. What's the easiest program to run to test if they're working? I've tried the shareware Quake with QuakeGL with no luck. What uses Glide?
#3
General Discussions / Testing Voodoo cards
11 May 2021, 20:28:14
Can anyone advise me please...

I have a number of Voodoo cards. My history started with The Voodoo 3 2000, both PCI and AGP (I still have the AGP in a retro W98 system).
Over the years I've saved from unwanted PC's a Banshee, a Maxi Gamer Phoenix voodoo 1 and a Creative Blaster Voodoo 2 (CT6670).

The Banshee I can handle, although haven't found the right driver for it yet. But the Voodoo 1 and 2 are proving troublesome.

I've found some old parts and have a QDI socket 7 motherboard with a Duron 1300 in. 256Mb of DDR ram, an ATI Riva TNT2 video card and a fresh install of Windows 98SE. I have found a driver for the Voodoo 2 that the PC is happy with, But I cant stop the PC using the TNT2 when running Quake. The card works through the pass through, but nothing else.

As for the Voodoo 1. Windows only see's it when I start swapping PCI slots....!!!!

I wish I had an old 2D 2mb card... I used to pick them up from the fairs for £4 (pre 2000). But eBay are after £20+ for one now and for all I know these cards might be Kaput.

Or could it be the Processor? I have a couple of K6 systems I could try them on. A K6-2-500 and a K6-3-400. Do you think that would help?

Thanks