Ok, I've not had luck with selecting motherboards for what I'm trying to do, so I have decided to ask you folks.

I have an ultra low voltage Athlon XP-M (currently pinmodded to 2.4ghz due to my poor motherboard, and still cold ), and a bunch of 3dfx cards with an AGP 3.3v requirement. I would like to know what the best motherboard for overclocking XP-M processors which has support for old 3.3v AGP cards is. I intend to also get an absurdly large amount of DDR memory that can handle a fsb overclock to work with it.

Toss some ideas at me please.

EDIT: It's actually the same motherboard as in my signature, but the fsb thing didn't work out, so it's 24x 100mhz now.

Is there some way to get the Steam version of the original Half-Life to run on a Voodoo 5500? I can get it to open with the 3dfx Community drivers (1.08.04) but I can't change any video settings, and it's very slow.

Also, I'd like to know if there's a driver that supports DirectX 8, because I'm trying to get TF2 to run on my Voodoo. XD

I'm trying to build a voodoo machine on an MSI KT3 Ultra2-R board with a 35watt XP-M 2400+ (to overclock, of course).

It will work fine with an older 1500+, but I can't get it to boot with the mobile. It's not even POSTing. The motherboard will boot up (the power switch will shut it off after 5 seconds) but there is no post screen, and I don't know what the problem is. There is no beep code, nothing.

Has anyone done this before?

I am trying to use a voodoo 5 5500 in a PCCHIPS M811 motherboard, and I cannot get it to boot past the summary screen, right before it SHOULD start windows. I just swapped out my x1600 to try it out, and it's not booting at all. I have it set to agp 2x, with video bios shadowing disabled, with 512mb of 266mb ddr memory, and a 333mhz FSB 2600+ running at 1.5 ghz (2000+, 266 mhz FSB). I have windows 2003 server installed. Anyone have any ideas?