Thanks a lot!!
someone is offering this to me...
and does it support 4X AGP(1.5V AGP) or not?
Thanks a lot !!
(https://www.3dfxzone.it/public/uploaded/secretfj/20051216125823_v4_4500.jpg)
it should be a powercolor v4
thanks, coz i haven't seen a V4 w/o TV out and low profile...
do you used it before?
i wanna use it on my new system with AGP4x/8x slots only, do you know does it support it or not?
no unfortunately i haven't any voodoo4
but i think it is fully agp4x compatible like any v4 from stb
before testing it on a agp8x mb wait for another answers because i'm not 100% sure
Even if this card is keyed like a 1.5 v, i will try it on a mobo compatible agp 1x or 2x 3.3 v.
I own a PowerColor low profile and this card runs only on a mobo 3.3v agp 2x.
do NOT use that card in a agp4x/8x slot,unless you like toasted hardware..
looks like an STB 3dfx V4 true and blue. should work just fine at 1.5V. it DOES have both notches. this board is DEFINATELY NOT a powercolor board.
QuoteOriginally posted by bloodworm
looks like an STB 3dfx V4 true and blue. should work just fine at 1.5V. it DOES have both notches. this board is DEFINATELY NOT a powercolor board.
It's a Powercolor clone and chances are runs at 3.3 volts AGP just like the Powercolor V4's.
oh, it makes me confused....
seems it's an uncommon card..
can you email me a BETTER more resolute picture of both the back AND the front?
Try the card in a mobo that has 4x/2x AGP slot. It cannot burn the card since in supports both 1.5V and 3.3V. If the card will work in 4x transfer mode, than it supports 1.5v signalling. Hence you can use it in 8x AGP slot. Also if you have hardware monitor in your bios, you can see the agp voltage. Again if the card works in agp 4x mode, the voltage shown will be 1.5v. Regards, Alpar