Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - SnaG

#1
hi

i need help to set up my drivers right...
i want performance not quality (FRAMERATE IS LIFE)
which driver should i choose?
which settings on the card?
(there are many in the 3dfx hub, which i doesn't understand whats faster...)
wanna get more 3Dmarks 2001 with it (at moment at 4014 @ 1024x768x32)

greetz SnaG
#2
hmm ok, i'll pick the 8k5a2+ cause its newer than the 8k3a+

greetz SnaG
#3
hmm, any other opinions??

greetz SnaG
#4
hi there

i know this is a well known topic,
but i am unsure which motherboard i should take..
This things should run on it, without any problems:
- V56K rev3700
- 3x 1GB Infineon CL2.5 DDR333
- Adaptec 29160 SCSI Controller (motherboard must allow boot on SCSI)
- Barton 3000+  FSB333

http://www.thedodgegarage.com/3dfx/v6k_faq.htm

the site says i can pick a Epox 8k3a+ or a 8k5a2+
which should i pick?
or are there any other opinions?

greetz SnaG
#5
hmm ok

thx again
#6
another question, can the card blow up (hint se-66)
if i put it in the false kt333 board ?
like a epox 8k5a2+ ? (the 8k5a was tested by logicalmadness)

greetz SnaG
#7
thank you guys:)
#8
General Discussions / 5500 connector to lcd
29 May 2004, 22:46:47
very interesting,
but if take a closer look on it there are 5 or 6 pins connected to the bios of the card
#9
i am looking for a compatible motherboard for a v56k rev3700
i know that it must be kt333 bu there are many of them:
Epox 8k3a+ : VIA KT333 AGPset (KT333CE+ VT8233A/8233) <-- will that work?

gr33tz SnaG