1024*768 on a single voodoo2-is it possible?

Started by ps47, 30 November 2003, 20:55:32

Previous topic - Next topic

ps47

just seen the preview for the fastvoodoo 4.0XP driver,1280*1024 with v2 SLI[:0],cool.is v2 SLI fast enough for a smooth gameplay in this resolution?and would it be possible to have 1024*768 on a single v2 with this driver?(for unreal tournament for example..)..man,fastvoodoo2 ruulz..[8D]

Glide

Wicked3D Win9x drivers series allowed running games at 1024x768 points on the screen with a single Voodoo2. These now are a little obsolete and besides require Wicked3D Voodoo2 for a succesfully completed installation (software check).

With FastVoodoo2 4.0 XP you will set up a resolution at 1024x768 on single Voodoo2 for only some OpenGL based games. In some case with Quake2 engine based games like Quake 2 or Heretic 2 you can go on until 1600x1200, with a single board.

Nightbird

well, one Wicked3D Voodoo2 : 1024*672
2 Wicked3D Voodoo2 : 1024*1024

the mode 1024*768 is only available with 2 Wicked3D Voodoo2 in sli

but all these resolutions are possible in D3D, QuakeGl and Glide
______________________________________________

In-ter-ac-tive :
The way video games were always meant to be played
______________________________________________

Welcome to 3dfxzone.it Community
_____________________________

Glide

Quotewell, one Wicked3D Voodoo2 : 1024*672
2 Wicked3D Voodoo2 : 1024*1024

It's right [:I]...tnx MOD ;)

skinnie

QuoteOriginally posted by Glide


With FastVoodoo2 4.0 XP you will set up a resolution at 1024x768 on single Voodoo2 for only some OpenGL based games. In some case with Quake2 engine based games like Quake 2 or Heretic 2 you can go on until 1600x1200, with a single board.

how can?do this work with fast voodoo 4.6 too?
MSI KT3/Athlon XP 2400+/2x256Mb OCZ BH5/3dfx Voodoo 3 3000 AGP

ps47

if you can disable z-buffer in the game options,you will be able to use higher resolutions,but this may cause artifacts.I was running thief2 in 1024*768 res on a single v2,the game was fine but the sky was broken.

skinnie

how can i disable z buffer in qauke and quake 2?is it possibel to run htese 2 games in 1024x768?
MSI KT3/Athlon XP 2400+/2x256Mb OCZ BH5/3dfx Voodoo 3 3000 AGP

ps47

check commands and variables.I'm not sure about q1,but it should be possible with q2 as I know for sure that heretic2 allows this,and the game uses q2 engine..but as I said,the results of disabling the z-buffer can be..questionable.