3dfxzone.it WorldWide Community

3dfx Hardware & Software => Voodoo4/5 Setup and tweaking => Topic started by: bareznacoff on 26 September 2003, 01:19:48

Title: Voodoo 5-5500PCI and Mall Tycoon 2
Post by: bareznacoff on 26 September 2003, 01:19:48
Can't get it to start. Kicks back to desktop. Need some suggestions or ideas.  My daughter is holding me hostage wanting to get this thing going.
Title: Voodoo 5-5500PCI and Mall Tycoon 2
Post by: qrazi on 26 September 2003, 09:47:07
hello! i downloaded the demo and it runs good on my system. i played it in 800x600x32... if you tried it in a 16 bit resolution, try using a 32 bit resolution, that might help....

Title: Voodoo 5-5500PCI and Mall Tycoon 2
Post by: bareznacoff on 26 September 2003, 18:38:04
It doesn't give me the option to run in 32 bit resolution in the game, only 16 bit resolution. Could be since it is only a P3600.  I'm guessing your using the Amigamerlin 2.5SE or the new 3.0 drivers.
Title: Voodoo 5-5500PCI and Mall Tycoon 2
Post by: qrazi on 28 September 2003, 11:08:53
cpu shouldnt be the issue, it would only make the game run slow (and judging by the graphics, 600mhz is more then enough...)

what card do you have? a voodoo3 doesnt support 32-bit... :D

ill downloa dit again, and try to run it in 16-bit...